Table 284: show route damping Output Fields
(continued)
Level of Output
Field Description
Field Name
detail extensive
How long the route has been known.
Age
detail extensive
Metric for the route.
Metric
detail extensive
Name of the protocol that has added the route.
Task
detail extensive
List of protocols that announce this route.
n-Resolve inet
indicates that the
route is used for route resolution for next hops found in the routing table.
n
is
an index used by Juniper Networks customer support only.
Announcement
bits
All levels
AS path through which the route was learned. The letters at the end of the AS
path indicate the path origin, providing an indication of the state of the route at
the point at which the AS path originated:
•
I
—IGP.
•
E
—EGP.
•
?
—Incomplete; typically, the AS path was aggregated.
When AS path numbers are included in the route, the format is as follows:
•
[ ]
—Brackets enclose the local AS number associated with the AS path if
more than one AS number is configured on the routing device or if AS path
prepending is configured.
•
{ }
—Braces enclose AS sets, which are groups of AS numbers in which the
order does not matter. A set commonly results from route aggregation. The
numbers in each AS set are displayed in ascending order.
•
( )
—Parentheses enclose a confederation.
•
( [ ] )
—Parentheses and brackets enclose a confederation set.
AS path
brief
none
Next hop to the destination. An angle bracket (>) indicates that the route is the
selected route.
to
brief
none
Interface used to reach the next hop. If there is more than one interface available
to the next hop, the interface that is actually used is followed by the word
Selected
.
via
detail extensive
Community path attribute for the route. See the output field table for the show
route detail command.
Communities
All levels
Local preference value included in the route.
Localpref
detail extensive
BGP router ID as advertised by the neighbor in the open message.
Router ID
detail extensive
Last updated and current figure-of-merit value.
Merit (last
update/now)
detail extensive
Name that identifies the damping parameters used, which is defined in the
damping statement at the
[edit policy-options]
hierarchy level.
damping-parameters
detail extensive
Time of most recent change in path attributes.
Last update
2189
Copyright © 2010, Juniper Networks, Inc.
Chapter 74: Operational Commands for Layer 3 Protocols
Summary of Contents for JUNOS OS 10.3 - SOFTWARE
