CHAPTER 102
Configuring Firewall Filters
•
Configuring Firewall Filters (CLI Procedure) on page 3063
•
Configuring Firewall Filters (J-Web Procedure) on page 3069
•
Configuring Policers to Control Traffic Rates (CLI Procedure) on page 3073
•
Assigning Multifield Classifiers in Firewall Filters to Specify Packet-Forwarding Behavior
(CLI Procedure) on page 3075
•
Configuring Routing Policies (J-Web Procedure) on page 3076
Configuring Firewall Filters (CLI Procedure)
You configure firewall filters on EX Series switches to control traffic that enters ports on
the switch or enters and exits VLANs on the network and Layer 3 (routed) interfaces. To
configure a firewall filter you must configure the filter and then apply it to a port, VLAN,
or Layer 3 interface.
•
Configuring a Firewall Filter on page 3063
•
Applying a Firewall Filter to a Port on a Switch on page 3066
•
Applying a Firewall Filter to a VLAN on a Network on page 3067
•
Applying a Firewall Filter to a Layer 3 (Routed) Interface on page 3067
Configuring a Firewall Filter
To configure a firewall filter:
3063
Copyright © 2010, Juniper Networks, Inc.
Summary of Contents for JUNOS OS 10.3 - SOFTWARE
