kernel-replication
—(Optional) Restart the kernel replication process, which replicates
the state of the backup Routing Engine when graceful Routing Engine switchover is
configured.
l2-learning
—(Optional) Restart the Layer 2 address flooding and learning process.
l2tp-service
—(Optional) (M10, M10i, and M7i routers only) Restart the Layer 2 Tunneling
Protocol (L2TP) process, which establishes L2TP tunnels and Point-to-Point Protocol
(PPP) sessions through L2TP tunnels.
lacp
—(Optional) Restart the Link Aggregation Control Protocol process.
lcc
number
—(TX Matrix and TX Matrix Plus routers only) (Optional) For a TX Matrix router,
restart the software process for a specific T640 router that is connected to the TX
Matrix router. For a TX Matrix Plus router, restart the software process for a specific
T1600 router that is connected to the TX Matrix Plus router. Replace
number
with a
value from
0
through
3
.
license-service
—(EX Series switch only) (Optional) Restart the feature license
management process.
link-management
— (TX Matrix and TX Matrix Plus routers and EX Series switches only)
(Optional) Restart the Link Management Protocol (LMP) process, which establishes
and maintains LMP control channels.
lldpd-service
—(EX Series switch only) (Optional) Restart the Link Layer Discovery Protocol
process.
mib-process
—(Optional) Restart the Management Information Base (MIB) II process,
which provides the router's MIB II agent.
mountd-service
—(EX Series switch only) (Optional) Restart the service for NFS mounts
requests.
multicast-snooping
—(EX Series switch only) (Optional) Restart the multicast snooping
process.
network-access-service
—(J Series router only) (Optional) Restart the network access
process, which provides the router's Challenge Handshake Authentication Protocol
(CHAP) authentication service.
pgcp-service
—(Optional) Restart the pgcpd service process running on the Routing Engine.
This option does not restart pgcpd processes running on mobile station PICs. To
restart pgcpd processes running on mobile station PICs, use the
services pgcp
gateway
option.
pgm
—(Optional) Restart the process that implements the Pragmatic General Multicast
(PGM) protocol for assisting in the reliable delivery of multicast packets.
pic-services-logging
—(Optional) Restart the logging process for some PICs. With this
process, also known as fsad (the file system access daemon), PICs send special
logging information to the Routing Engine for archiving on the hard disk.
Copyright © 2010, Juniper Networks, Inc.
268
Complete Software Guide for Junos
®
OS for EX Series Ethernet Switches, Release 10.3
Summary of Contents for JUNOS OS 10.3 - SOFTWARE
