NOTE:
Interfaces xe-0/0/0 through xe-0/0/39 are the network interface
ports. Optional uplink modules provide four 10-gigabit small form-factor
pluggable (SFP+) transceivers (xe-0/1/0 through xe-0/1/3) or four 1-gigabit
small form-factor pluggable (SFP) transceivers (xe-0/2/0 through xe-0/2/3).
Although you can install only one uplink module, the interfaces for both are
shown below.
When you commit changes to the configuration, a new configuration file is created, which
becomes the active configuration. You can always revert to the factory default
configuration. See “Reverting to the Default Factory Configuration for the EX Series
Switch” on page 427.
This topic shows the factory default configuration file of an EX4500 switch:
system {
syslog {
user * {
any emergency;
}
file messages {
any notice;
authorization info;
}
file interactive-commands {
interactive-commands any;
}
}
commit {
factory-settings {
reset-chassis-lcd-menu;
reset-virtual-chassis-configuration;
}
}
}
interfaces {
xe-0/0/0 {
unit 0 {
family ethernet-switching;
}
}
xe-0/0/1 {
unit 0 {
family ethernet-switching;
}
}
xe-0/0/2 {
unit 0 {
family ethernet-switching;
}
}
xe-0/0/3 {
unit 0 {
Copyright © 2010, Juniper Networks, Inc.
410
Complete Software Guide for Junos
®
OS for EX Series Ethernet Switches, Release 10.3
Summary of Contents for JUNOS OS 10.3 - SOFTWARE
