The configuration of the appliance as a Junos Space node or an FMPM node is now
complete. If you configured the appliance as a Junos Space node, you can access the
node by typing the address configured for the Web GUI in a browser.
NOTE:
After you configure an FMPM node, you must add it to the Junos Space
fabric using the Junos Space Network Management Platform. For more
information, see the Adding a Node to an Existing Junos Space Fabric topic in
the Junos Space Network Management Platform Workspaces Feature Guide.
Step 7 (Optional): Configuring the eth1 Interface
You use the eth1 interface as the administrative interface for the Junos Space or FMPM
node. When the Junos Space or FMPM node reboots after the basic configuration,
configure the eth1 interface.
NOTE:
•
From Junos Space Network Management Platform Release 14.1R1 onward,
you can configure the eth1 Ethernet interface as an administrative interface.
•
The eth1 interface must be configured separately for each node in a
multinode fabric.
•
If you configure the eth1 interface, SSH is disabled on the eth0 and the eth3
interfaces. You can then access the CLI of the Junos Space appliance only
through the eth1 interface.
To configure the eth1 interface:
1.
On the Junos Space Settings Menu, type
6
to access the shell.
You are prompted to enter your password.
2.
Type your password and press Enter.
The shell prompt appears.
3.
At the shell prompt, type
jmp_config
and press Enter.
You are prompted to enter the IP address of the eth1 interface.
4.
Type the IP address of the eth1 interface in dotted decimal notation and press Enter.
The IP address can be in the same subnet as the virtual IP (VIP) address or in a different
subnet. If the IP address is not in the same subnet as the VIP address, you are prompted
to enter the subnet mask and then the default gateway for the eth1 interface.
25
Copyright © 2018, Juniper Networks, Inc.
Step 7 (Optional): Configuring the eth1 Interface
