Copyright © 2010, Juniper Networks, Inc.
Resolved Known Problems
53
Release 11.1.1
IGMP
z
Multicast forwarding stops when OIF is flapped; IGMP state on OIF shows up no
groups learnt but queries/reports are counted. [Defect ID 90314]
z
Deadlock igmp - ipHelper while testing the fix for 90323. [Defect ID 90547]
IP
z
bfd last-resort also enables rtr last-resort. [Defect ID 89510]
z
100 % CPU utilization after issuing the show ip socket statistics detailed command.
[Defect ID 90751]
IPv6
z
IPv6 ND over dynamic interface doesn't work on ERX if it acts as LNS. [Defect ID
88378]
z
IPSec with NAT reports inboundSa = invalidAlgorithm when show ipsec tunnel detail
command is used. [Defect ID 90642]
IS-IS
z
ISIS in out-of-memory state and SRP-switch keeps ISIS remain down. [Defect ID
90482]
L2TP
z
SRP reset type: processor exception 0x68616c74 (halt) task: ip_Ctrl_2 [Defect ID
90472]
MPLS
z
MPLS RSVP reoptimize cause SRP memory leak. [Defect ID 90366]
z
LDP and OSPF flap when an unconfigured LM10 is reloaded with 75k MPLS next
hops. [Defect ID 90471]
z
LM10U reset type panic file: aptationLayer.cc line: 3159
Hw2MplsAdaptationLayer::setEgressDirectNextHopLabel [Defect ID 90732]
Multicast
z
Unsupported IPv6 PIM Data MDT Commands in CLI [ Defect ID 83791 ]
The
ipv6 pim data-mdt
command and the
show ipv6 pim data-mdt
command are
unsupported in the current release.
The IPv6 PIM Data MDT Configuration mode is unsupported in this release. The
following commands appear in IPv6 PIM Data MDT Configuration mode but are
unsupported in the current release:
z
ipv6 pim join-filter
z
mdt-data-timeout
z
ipv6 pim query-interval
z
route map
z
mdt-data-delay
z
tunnel group-address-pool
z
mdt-data-holdown
z
tunnel source