• When pressed for fewer than 5 seconds for diagnostic purposes, the RCB does not reset. The
press event is logged in the RCB FPGA register.
• When pressed for more than 5 seconds but fewer than 10 seconds, the RCB reboots and the
reset-reason logs the button press event.
• When pressed for more than 10 seconds, the RCB reboots with an option for BIOS recovery.
• LEDs—Provide status of the Routing Engine.
• Online/Offline Button—When the RCB is online, and if the button is pressed for more than 4
seconds, the RCB goes offline. When the RCB is offline, and if the button is pressed more than 4
seconds, the RCB starts booting.
NOTE: For specific information about Routing Engine components (for example, the amount of
DRAM), issue the
show vmhost hardware
command.
MX10004 Routing and Control Board LEDs
IN THIS SECTION
Routing and Control Board Status Panel LEDs | 60
MX10004 Management Port LEDs | 62
59
