Software features
•
Supports rate selectability at the port level.
•
By default, the ports are configured as 10-Gigabit Ethernet ports.
•
Optical diagnostics and related alarms.
Power requirements
Line-rate throughput of 2.4 Tbps:
•
Power consumption at different temperatures:
25° C: 1335 W
40° C: 1425 W
LEDs
OK/FAIL LED:
•
Steady green—MPC is functioning normally.
•
Yellow—MPC has failed.
Port LED—Link
•
Off—Port is not enabled.
•
Green—Port link is up with no alarms or failures.
•
Red—Port link is down with alarms.
NOTE: When a QSFP+ port is configured for the 10-Gigabit mode with a breakout cable, the link status for the 10-
Gigabit port is indicated with the addition of four LEDs provided on the line card. The lane LEDs for the
corresponding port indicates the port status.
Like the port status LED, each individual lane LED supports four states as: OFF, AMBER, GREEN, RED. See
and MIC Lane LED Scheme Overview
for more details.
For the 40-Gigabit mode the lane number LED is not applicable. The port LED indicates the port status, irrespective
of whichever lane number LED is ON.
Cables and
connectors
TIP: You can use the
to find information about the pluggable transceivers supported
on your Juniper Networks device.
The list of supported transceivers for the MX Series is located at
MX Series Supported Transceivers
69
