CAUTION: Do not stack line cards on top of one another or on top of any other
component. Place each line card separately in the antistatic bag or on the antistatic
mat placed on a flat, stable surface.
CAUTION: Be prepared to support the full weight of the line card as you slide it out of
the chassis.
7. Grasp both sides of the line card at midpoint and remove the line card from the chassis. Either have
someone assist you in placing the line card into the antistatic bag or rest the card on the antistatic
mat. Take care not to bump or store the line cards on the connectors. See
.
8. If you removed an MX10K-LC9600 from the router, re-insert the protective plastic cover on the
fabric interface connectors of the line card to keep the connectors clean and free of dust and other
particles (see
).
Figure 95: Insert Protective Plastic Cover on MX10K-LC9600 Interface Connectors
9. If you are not installing a line card in the emptied line-card slot within a short time, install a cover
over the slot. Do this to protect the interior of the chassis from dust or other foreign substances and
to ensure that the airflow inside the chassis is not disrupted.
Install the MX10004 Cable Management System
The Juniper Networks MX10004 router's cable management system is an optional, orderable kit (JLC-
CBL-MGMT-KIT). This kit organizes and protects optical cabling attached to the line cards. After you
install a line card, you can still remove the line card without needing to remove the cable management
system.
200
