This topic describes these tasks:
1.
Calculating the Power Consumption of Your MX10008 Configuration | 101
2.
Calculating the Number of Power Supplies Required for Your MX10008 Configuration | 102
Calculating the Power Consumption of Your MX10008 Configuration
Use the following procedure to determine the maximum power you need to supply to the router. To
calculate maximum system power consumption, you first determine the combined maximum internal power
requirements of all the router components and then divide this result by the power supply output power.
To calculate maximum system power consumption:
1. Determine the maximum power consumption of the base chassis components (that is, the components
other than the line cards). Use
if your router is configured as either the standard
base or redundant configuration.
Table 31: Chassis Power Consumption for Standard Configurations
Redundant Configuration
Base Configuration
Chassis Component
1100 W
1100 W
Fan tray, JNP10008-FAN
1212 W
1212 W
Fan tray, JNP10008-FAN2
350 W/330 W
175 W/165 W
Routing and Control board (128G/64G) @40°
C
1200 W
1000 W
Switch fabric board (SFB)
2. Calculate the maximum internal power consumption of the entire router by adding in the power
requirements of each line card. See
for a chart of the power needed for line cards.
Table 32: Line Card Power Consumption
MX10K-LC2101 (400 Gigabit
Ethernet mode @104° F (40°
C))
MX10K-LC2101 (240 Gigabit
Ethernet mode @104° F (40°
C))
Number of Line Cards
1425 W
1175 W
1
2850 W
2350 W
2
4275 W
3525 W
3
101
Summary of Contents for MX10008
