Figure 1: Removing a Power Supply Before Installing the MX960 Router
Removing the Standard Cable Manager Before Installing an MX960 Router Without a Lift
To remove the standard cable manager (see Figure 2):
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and
connect the strap to one of the ESD points on the chassis.For more information
about ESD, see Preventing Electrostatic Discharge Damage to an M Series, MX
Series, or T Series Router.
2.
Using a 7/16-in. (11 mm) nut driver, unscrew the nuts on the corners of the
standard cable manager.
3.
Grasp the bottom of the standard cable manager and pull it straight out from
the studs on the front of the chassis.
2
■
Removing the Standard Cable Manager Before Installing an MX960 Router Without a Lift
