Connecting the NetScreen-200 Device to Other Devices
NetScreen-200 Series
13
&
211(&7,1*
7+(
1
(7
6
&5((1
'
(9,&(
72
2
7+(5
'
(9,&(6
To connect the device, use the ethernet interfaces (ethernet1 through ethernet4 on the
NetScreen-204, or ethernet1 through ethernet8 on the NetScreen-208). The purpose of
each interface depends upon the security zone to which it is bound.
By default, the zone and interface bindings are as follows:
•
ethernet1 is bound to the Trust security zone by default.
Connect this interface using a twisted pair cable with RJ-45 connectors.
•
ethernet2 is bound to the DMZ security zone by default.
Connect this interface using a twisted pair cable with RJ-45 connectors.
•
ethernet3 is bound to the Untrust security zone by default.
Connect this interface using a twisted pair cable with RJ-45 connectors.
•
ethernet4 through ethernet8: Can be connected as required.
The default IP address of each ethernet interface is 0.0.0.0/0.
For information on interfaces and security zones, see
“The NetScreen-200 Series Device
Interfaces” on page 17
.
