Performing Initial Configuration Using the CLI
NetScreen-50
17
3
(5)250,1*
,
1,7,$/
&
21),*85$7,21
8
6,1*
7+(
&/,
There are two ways to establish a console session with the NetScreen-50 device:
•
Using a vt100 terminal emulator, such as Hilgraeve
®
Hyperterminal
®
, t
hrough
an RJ-45 serial cable connected to the console port.
•
Using Telnet through a TCP/IP network connection to the NetScreen-50 device.
&RQQHFWLQJ8VLQJDYW7HUPLQDO(PXODWRU
To establish a connection to the NetScreen-50 device using a vt100 Terminal Emulator:
1.
Connect an RJ-45 serial cable between the console port on the NetScreen-50
device and the serial port on your PC.
2.
Start the vt100 terminal emulator program on your PC.
Typical settings for a console session are as follows:
• Baud Rate to 9600
• Parity to No
• Data Bits to 8
• Stop Bit to 1
• Flow Control to none
3.
Press the ENTER key to see the login prompt.
4.
At the login prompt, type
netscreen.
5.
At the password prompt, type
netscreen.
6.
(Optional) By default, the console times out and terminates automatically after
10 minutes of idle time. To change the timeout value, execute the following
command:
set console timeout number
where number is the length of idle time, in minutes, before session termination.
To prevent automatic termination, specify a value of zero.
Note:
Use lowercase letters only. Both login and password are case-sensitive.
Summary of Contents for NetScreen-50
