Removing and Installing SFP and XFP Transceivers
55
Servicing the Device
Removing and Installing SFP and XFP Transceivers
To remove an SFP or XFP transceiver from a module:
1.
Push in the black ejector (located on the underside of the transceiver) until it
locks into place, disengaging the transceiver.
2.
Grasp the transceiver at both sides, and then pull the transceiver toward you to
remove it from the module.
To install an SFP or XFP transceiver into a module:
1.
Grasp the transceiver with the label facing up, and then insert it into the
transceiver slot until seated.
2.
Check to see if the black transceiver ejector extends fully out to the front of the
ejector slot, flush with the port portion of the transceiver.