![background image](http://html1.mh-extra.com/html/juniper/ptx10001-36mr/ptx10001-36mr_hardware-manual_2032720128.webp)
b. Grasp the transceiver ejector lever and gently slide the transceiver approximately 0.5 in. (1.3 cm)
straight out of the port.
CAUTION: To prevent ESD damage to the transceiver, do not touch the connector
pins at the end of the transceiver.
Figure 48: Remove an SFP+ or QSFP+ Transceiver
1
—
Ejector lever
7. Using your fingers, grasp the body of the transceiver and pull it straight out of the port.
8. Place the transceiver in the antistatic bag or on the antistatic mat placed on a flat, stable surface.
9. Place the dust cover over the empty port, or install the replacement transceiver.
Install a Transceiver
Before you install a transceiver in a device, ensure that you have taken the necessary precautions for
safe handling of lasers (see
Laser and LED Safety Guidelines and Warnings
Ensure that you have a rubber safety cap available to cover the transceiver.
NOTE: After you insert a transceiver or after you change the media-type configuration, wait for
6 seconds for the interface to display operational commands.
NOTE: We recommend that you use only optical transceivers and optical connectors purchased
from Juniper Networks with your Juniper Networks device.
119