CAUTION:
We recommend using a surge protector for the power connection.
NOTE:
Before the services gateway is fully configured and running, you might
hear a crackling noise from the power supply unit. This noise is temporary
and stops after the device is configured.
Related
Documentation
Required Tools and Parts for Installing and Maintaining the SRX220 Services Gateway
on page 46
•
•
Grounding the SRX220 Services Gateway on page 66
•
Connecting and Organizing Interface Cables for the SRX220 Services Gateway on
page 69
•
SRX220 Services Gateway General Safety Guidelines and Warnings on page 127
Powering On and Powering Off the SRX220 Services Gateway
This topic describes the following procedures:
1.
Powering On the SRX220 Services Gateway on page 74
2.
Powering Off the SRX220 Services Gateway on page 75
3.
Resetting the SRX220 Services Gateway on page 76
Powering On the SRX220 Services Gateway
To power on the services gateway:
1.
Ensure that you have connected the power supply to the device.
2.
Insert the plug of the power supply adapter into an AC power source receptacle.
3.
Turn on the power to the AC power receptacle and press the Power button.
The device starts automatically as the power supply completes its startup sequence.
The Power LED lights green during startup and remains on when the device is operating
normally.
NOTE:
After the power supply is turned on, it can take up to 60 seconds for
status indicators—such as the Status and Power LEDs—to show that the
power supply is functioning normally.
NOTE:
If you want to power the device off immediately after you power it
on, we recommend that you shut down the device using the command-line
interface (CLI)
request system power-off
command.
Copyright © 2016, Juniper Networks, Inc.
74
SRX220 Services Gateway Hardware Guide for H Model Numbers
