Junker JD66BW50, Instructions For Installation And Use Manual

15

Operating the appliance

These instructions apply to several appliance variants. It is 

possible that individual features are described which do not 

apply to your appliance.

Note: 

Switch on the extractor hood when you start cooking and 

switch it off again several minutes after you have finished 

cooking. This is the most effective way of removing the kitchen 

fumes.

Control panel

Setting the fan

Switching on

Press button 1, 2 or 3.

Switching off

Press the 0 button.

Lighting

The lighting can be switched on and off independently of the 

ventilation.
Press the 

A

 button.

Cleaning and maintenance

: 

Risk of burns!

The appliance will become hot during operation, especially 

near the bulbs. Allow the appliance to cool down before 

cleaning.

: 

Risk of electric shock!

Penetrating moisture may result in an electric shock. Clean the 

appliance using a damp cloth only. Before cleaning, pull out the 

mains plug or switch off the circuit breaker in the fuse box.

: 

Risk of electric shock!

Do not use any high-pressure cleaners or steam cleaners, 

which can result in an electric shock.

: 

Risk of injury!

Components inside the appliance may have sharp edges. Wear 

protective gloves.

Cleaning agents

To ensure that the different surfaces are not damaged by using 

the wrong cleaning agent, observe the information in the table. 

Do not use any of the following:

■

Harsh or abrasive cleaning agents,

■

Cleaning agents with a high alcohol content,

■

Hard scouring pads or cleaning sponges,

■

High-pressure cleaners or steam cleaners.

Wash new sponge cloths thoroughly before use.
Follow all instructions and warnings included with the cleaning 

agents.

Explanation

A

Light On/Off

0.1 Fan Off/Fan speed 1
2

Fan speed 2

3

Fan speed 3

Area

Cleaning agent

Stainless steel

Hot soapy water: 

Clean with a dish cloth and then dry 

with a soft cloth.
Clean stainless steel surfaces in the 

grind direction only.
Special stainless steel cleaning prod-

ucts are available from our after-sales 

service or from specialist retailers. 

Apply a very thin layer of the cleaning 

product with a soft cloth.

Painted surfaces

Hot soapy water: 

Clean using a damp dish cloth and dry 

with a soft cloth/towel.
Do not use any stainless steel cleaners.

Aluminium and plas-

tic

Glass cleaner: 

Clean with a soft cloth.

Glass

Glass cleaner: 

Clean with a soft cloth. Do not use a 

glass scraper.

Controls

Hot soapy water: 

Clean using a damp dish cloth and dry 

with a soft cloth/towel.
Risk of electric shock caused by pene-

trating moisture.
Risk of damage to the electronics from 

penetrating moisture. Never clean 

operating controls with a wet cloth.
Do not use any stainless steel cleaners.