Junker JD66BW50, Instructions For Installation And Use Manual

16

Cleaning the metal mesh grease filters

These instructions apply to several appliance variants. It is 

possible that individual features are described which do not 

apply to your appliance.

: 

Risk of fire!

Grease deposits in the grease filter may catch fire.

Clean the grease filter at least every 2 months. 

Never operate the appliance without the grease filter.

Notes

■

Do not use any aggressive, acidic or alkaline cleaning 

agents.

■

When cleaning the metal mesh grease filters, also clean the 

holder for the metal mesh grease filters in the appliance 

using a damp cloth.

■

The metal mesh grease filters can be cleaned in the 

dishwasher or by hand.

By hand:
Note: 

You can use a special grease solvent for stubborn dirt. It 

can be ordered via the Online Shop.

■

Soak the metal mesh grease filters in a hot soapy solution. 

■

Clean the filters with a brush and then rinse them thoroughly.

■

Leave the metal mesh grease filters to drain.

In the dishwasher:
Note: 

If the metal mesh grease filters are cleaned in the 

dishwasher, slight discolouration may occur. This has no effect 

on the function of the metal mesh grease filters.

■

Do not clean heavily soiled metal mesh grease filters together 

with utensils.

■

Place the metal mesh grease filters loosely in the dishwasher. 

The metal mesh grease filters must not be wedged in.

Removing metal grease filter

1.

Open the lock and fold down the metal grease filter.
When you do this, take hold of the metal grease filters from 

underneath with your other hand.

2.

Take the metal grease filter out of the holder.

Notes

■

Fat may accumulate in the bottom of the metal grease filter.

■

Hold the metal grease filter level to prevent fat from 

dripping out.

3.

Clean the metal grease filters.

Installing the metal mesh grease filter

1.

Insert the metal mesh grease filter.
While doing this, place the other hand under the metal mesh 

grease filter.

2.

Fold the metal mesh grease filter upwards, locking it in place.

Trouble shooting

Malfunctions often have simple explanations. Please read the 

following notes before calling the after-sales service.

: 

Risk of electric shock!

Incorrect repairs are dangerous. Repairs may only be carried 

out and damaged power cables replaced by one of our trained 

after-sales technicians. If the appliance is defective, unplug the 

appliance from the mains or switch off the circuit breaker in the 

fuse box. Contact the after-sales service.

Malfunction table

--------

Problem

Possible cause Solution

The appliance 

does not work

The plug is not 

plugged in.

Connect the appliance to 

the electricity supply

Power cut

Check whether other 

kitchen appliances are 

working

Faulty fuse

Check in the fuse box to 

make sure that the fuse for 

the appliance is OK

The lighting 

does not work.

The bulbs are 

faulty.

For information on chang-

ing the bulbs, see the 

"Replacing Bulbs" section.