10
11
ENGLISH
ENGLISH
ASSEMBLY
4 mm Allen Key (included)
Electric Screwdriver
and/or Power Drill
Tape Measure
TOOLS / ASSEMBLY
1
8
2
9
3a
10
3b
11
4
12
6
6
5
13
6
14
7
Leg 2
Foot 2
Frame End-CB
1
Frame End
1
Center Rail
2
Side Bracket
2
Control Box
1
Handset 1
Power Cord
1
Cable (1.3m)
1
M6 x 10 Machine Screw
16
M6 x 14 Machine Screw
12
M5 x 20 Wood Screw
11
M5 x 16 Wood Screw
2
Cable Clip
10
Nr. Part
Qty
Nr. Part
Qty
Lay out all components and hardware to ensure that you have all the components and hardware listed on the parts poge.
Slide the Control Box
(part 6)
off the Frame End-CB
(part 3a)
and set aside. Fully separate Frame End
(part 3b)
from
Frame End-CB
(part 3a).
You will find the Center Rails
(part 4)
inside.
Place one of the Legs
(part l)
into the Frame End-CB
(part 3a)
ensuring that the
bar (arrow) is on „top“ in relation to the Leg
(part l )
. Line up the holes on the Leg
(part l)
with the holes on the Frame End-CB
(part 3a)
. Using the supplied Allen Key,
insert four (4) M6 x 10 Machine Screws
(part 10)
through the holes in the Frame
End-CB
(part 3a)
, going into the Leg
(part l)
and rotate each screw just a few
turns. After all the four (4) M6 x 10 Machine Screws
(part 10)
are inserted, tighten
the four (4) screws. Do the same for the other Leg
(part l)
and the Frame End
(part
3b)
. If you drop a screw inside the frame end, simply tilt to retrieve.
If you drop a screw inside the frame end, simply tilt to retrieve.
The Frame End-CB
(part 3a)
should be placed on the side of the desk where you
plan to attach the Control Box
(part 6)
and the Handset
(part 7)
.
Slide the Side Bracket
(part 5)
into the Frame End-CB
(part 3a)
. Insert two
(2)
M6 x 14 Machine Screws
(part l l)
through the two (2) holes in the bottom of
the frame end/leg assembly and into the tabs in the Side Bracket
(part 5)
.
Using the supplied Allen Key, rotate each screw just a few turns. After both
M6 x 14 Machine Screws are inserted, tighten both screws.
Do the same for the other frame end/leg assembly.
Slide the two (2) Center Rails
(part 4)
into the two
Frame Ends
(parts 3a & 3b)
ensuring that:
a) the slots in the Center Rails
(part 4)
face inward
b) the slots in the Center Rails
(part 4)
are closer
to the top edge, as assembly is carried out upside
down (see inset).
For each leg assembly, attach a Foot
(part 2)
with
four (4) M6 x 14 Machine Screws
(part 11)
and
tighten in a cross-pattern.
2.
1.
3.
4.
5.
