What to do if ...
48
Changing the light bulb
1
Warning! There is a risk of electric shocks! Before changing the
light bulb, switch off the appliance and unplug it, or pull the fuse
or the circuit breaker.
Light bulb data: 220-240 V, max. 15 W, fitting: E 14
0
To switch off the appliance, turn the temperature regulator to
position "0".
0
Unplug the mains plug.
Interior lighting does not
work.
Light bulb is defective.
Please look in the
"Changing the Light
Bulb" section.
Heavy build up of frost,
possibly also on the
door seal.
Door seal is not air tight
(possibly after changing
over the hinges).
Carefully warm the lea-
king sections of the door
seal with a hair dryer
(not hotter than approx.
50 °C). At the same time
shape the warmed door
seal by hand such that it
sits correctly.
Unusual noises.
Appliance is not level.
Readjust the feet.
The appliance is tou-
ching the wall or other
objects.
Move the appliance
slightly.
A component, e.g. a
pipe, on the rear of the
appliance is touching
another part of the
appliance or the wall.
If necessary, carefully
bend the component
out of the way.
The compressor does
not start immediately
after changing the tem-
perature setting.
This is normal, no error
has occurred.
The compressor starts
after a period of time.
Water on the floor or on
storage shelves.
Water drain hole is blok-
ked.
See the "Cleaning and
Care" section.
Malfunction
Possible Cause
Remedy
