10
Fixing the hood
Apply the scheme supplied (Nº 49A) on the
right of the cabinet so that the lines marked
by the arrows match the cabinet ensuring
that they meet at the back and under.
Make two Ø 2 mm holes at points 1 and
2 (fig. 3).
Carry out the same operation on the left.
Fix the hood to the cabinet using screws E
(4,5x16) supplied with the appliance (fig. 3).
Use the shim F supplied with the hood for 16
mm cupboard side panels.
Fit the shim F to the left and to the right of
the fixing curves of the hood and hook them
in the holes.
Adjusting the removable drawer
The hood may be mounted in cabinets with
different depths.
The back of the drawer can be adjusted so
that the front of the removable drawer is the
same depth as the cabinet.
Proceed as follows: unscrew the screws G,
move the square plates H as required and
tighten the screw G (fig. 4).
Operation
The hood has one variable speed motor.
For the best performance, we recommend
using the low speeds in normal conditions
and the high speeds in particular cases of
strong odour and vapour concentration.
We recommend starting up the hood a few
minutes before cooking and keeping it
running until all the odours have been
eliminated.
A -
Motor OFF button
B -
ON button and motor speed selection
button 1 - 2 - 3 - 1 - 2 - . . . .
E -
Speed 1 LED
F -
Speed 2 LED and grease filter
saturation LED (flashes)
C -
Speed 3 LED and carbon filter
saturation LED (flashes)
D -
Intensive speed indicator LED
G -
Intensive speed ON switch
This speed should be used when the
concentration of cooking fumes or
odours is particularly strong (for
example when frying, cooking fish
etc.).
The fast speed will run for about 5
minutes and then return to the speed
previously set automatically (1, 2 or
3), or switch off if no speed was
selected. To turn off the fast speed,
before the end of the 5 minutes,
press button A or button B.
H -
OFF lamp button
I
-
ON lamp button
If the hood fails to operate correctly, briefly
disconnect it from the mains power supply
for almost 5 sec. by pulling out the plug.
Then plug it in again and try once more
before contacting the Technical Assistance
Service.
B
E
F
C
D G
A
H
I