11
Filter saturation control devices for
grease filters
This hood is supplied with a device that
notifies the user when the grease filter must
be cleaned or the charcoal filter replaced (if
installed).
Upon installation, the saturation control
device for the charcoal filter is not activated
(the hood is ready for use in vent mode).
In the event, you would like to install a
charcoal filter, activate the saturation control
device by pressing the B and G buttons at
the same time for 3 seconds.
at the start of this procedure, only the F Led
will blink, after 3 seconds have passed, the
C Led will begin to blink, as well to indicate
that the saturation control device for the
charcoal filter has been activated.
Grease filter saturation Led
The Led marked F flashes to warn you when
the grease filter needs to be cleaned.
Carbon filter saturation Led
The Led marked C flashes to indicate carbon
filter needs to be replaced.
Reset for the saturation control
devices for grease and charcoal filters
Once the grease filters have been cleaned
or the charcoal filter replaced, press the A
button for approximately 3 seconds until
you hear the (beep):
The F led and C led (if active) will stop
blinking.
The hood has an ON/OFF button.
Switch OFF the hood using this switch if the
hood is not to be used for a long period of
time.
In the case of failure, switch OFF the hood
using this button and wait for about 5
seconds; now turn ON the hood using the
same button.
Before using this button, use the
switch to switch off the motors or push in the
drawer in order to prevent the filter saturation
device from operating inefficiently.
Important! When carrying out maintenance
or repairs, this appliance must be unplugged
from the mains and not simply turned off
with this switch.
Maintenance
Before performing any maintenance
operation, disconnect the hood from the
electricity.
Metal grease filter
Wash the filter, in a dishwasher or with
detergent and water, periodically according
to how often the appliance is used, but at
least once every 4 weeks.
Attention! When washed in a dishwasher,
the metal grease filter may discolour.
Before refitting the filter ensure that it is
perfectly dry.
To remove this filter push simultaneously
the two handle Q towards the centre of the
cooker hood then extract them (fig. 5).
Grill and metal filter are a unique indivisible
component and they cannot be divided, to
avoid any damage to it.
