11
4.3 - Electrical connection and functional check
1 - Precautions 3.2, 3.3 and 3.4 of paragraph 3 on safety must be scrupulously adhered to.
2 - Make the electrical connection, check for proper functioning of the light, motor and change
of speed.
4.4 - Exhaust or filter connection
1 - Exhaust connection
a) The hood must be connected to external piping by means of a rigid or flexible 120 or 150
Ø pipe, as chosen by the installer. To install a 120 Ø pipe, the reduction flange
A
must be
placed at the hood outlet (fig. 4).
b) Connect the air outlet to the external pipe using the rigid or flexible pipe, using tightening
bands. Suitable material for this operation must be supplied by the installer.
c) Remove active carbon filters, if applicable (see paragraph 3.3.2, part 2).
2 - Filter connection
a) Filtered air is returned to the room through the directional grill
G
, to be mounted above
the shelf (fig. 5).
b) Add active carbon filters, if applicable, to the inside of the hood unit (see paragraph 3.3.2,
part 2).
4.5 - Mounting the telescopic chimney stack
1 - Fixing the telescopic chimney stack
a) The upper stack
S
must be fixed to the ceiling or to the shelf that delimits the upper part of
the kitchen units, as follows:
a) The chimney stack fitting
R
must be separated from the inside ring
F
by cutting the four
joining tabs (fig. 6). Part
D
may be used if an intermediary shelf is installed.
c) Position ring
F
on the ceiling or upper shelf in line with the hood outlet (
fig. 7
) and fix it
with two screws, if on the shelf, or two screws and two rawl plugs (provided) if to the ceiling.
d) Insert the upper chimney stack inside the lower chimney stack, along with the 120 Ø mm
connection pipe. Connect the connection pipe to flange
A
, then press the lower chimney stack
into the hood unit. During this assembly operation, take care to keep the series of fixing holes
in view (
fig. 8
). Push the upper chimney stack until it is inserted in the ring
F
. Fix the upper
chimney stack with the lower chimney stack by inserting in the appropriate hole one of the
screws supplied with the accessories (
fig. 9
). Turn the telescopic chimney stack until the series
of holes is facing the wall (
fig. 10
).
2 - Installation of an intermediary shelf.
a) Make a hole in the shelf so that the pipe can be inserted (
fig. 11
).
b) Part
D
, removed previously from fitting
R
, must be inserted in the telescopic chimney stack
before fixing to the hood, bearing in mind that it must be fixed to the lower part of the shelf.
c) Insert the shelf in the chimney stack and fix part
D
with the three screws provided (
fig. 12
).
Part 1 - INSTALLATION INSTRUCTIONS
Summary of Contents for JDK7090G
