JUNO JDK7530E, Installation, Use And Maintenance Handbook

12

1 - Safety warnings

It is most important that all the warnings shown in paragraph 3 of the Installation
Instructions are strictly observed. Moreover, pay special attention to the following war-
nings during the use and maintenance of the cooker hood:

1.1- The grease filters and the charcoal filter should be cleaned or replaced as recommen-ded

by the manufacturer or more frequently if the hood is used consistently over 4 hours per
day.

1.2- When using a gas hob in connection with the cooker hood never leave the burners of the

hob uncovered while the hood is in use or when the pans have been removed. Switch off
the gas before removing the pan, or for just short periods and never leave the hob
unattended.

1.3- Always ensure that the flame is kept at the correct intensity to prevent the flame from

licking round from the bottom of the pan; this will save energy and will avoid a dan-
gerous concentration of heat.

1.4- Always ensure that the appliance is used in accordance with the manufacturer’s instruc-

tions for the removal of contaminated air and odours during cooking.

2 - OPERATION

Control panel (fig. 7)

The cooker hood can be operated as follows:
SWITCH 

L

= controls the worktop illumina-tion;

SWITCH 

M

= controls the power to the motor;

SWITCH 

V

= controls the fan speed:

Position 1

= low speed, should be selected when simmering or using only one pan; the

noise level is kept to the minimun.

Position 2

= medium speed, should be selected for normal cooking. This speed of-fers the

best ratio between air capacity and noise level.

Position 3

= top speed, should be selected when frying or cooking food with strong

odours, even for a long period.

3 - MAINTENANCE

Regular maintenance and cleaning will ensure good performance and reliability, while
extending the working life of the hood. Special attention should be paid to the grease filters
and to the charcoal filters when the hood is used in the recirculation mode.

3.1 - Metal grease filters

1 - Cleaning

The metal grease filter should be cleaned every two months with normal usage and can be
cleaned in a dishwasher or by hand using a mild detergent or liquid soap.

2 - Replacement

Remove the filter pushing the handle towards the rear of the hood 

(fig. 8)

. When replacing,

ensure that the handle faces outwards.

Part 2

a

 OPERATION AND MAINTENANCE INSTRUCTIONS