11
6. The angle frame has one long arm and
one short arm, to be used in alternative
depending on the depth of the cupboards.
Using the hood
The hoods
JDS 3530
is supplied with 2
motors.
To get best efficiency, we suggest to use
slow speeds in normal conditions and the
highest in particular cases of strong smell
and vapour concentration.
The hood is provided with an intensive
speed.
Use the intensive speed switch only in case
of high concentration of vapour.
The switching plate is fitted with two switches:
one for the adjustment of the ventilator and
one for illuminating the work surface .
Note: Simply close the front panel to switch
off the hood (light and motor).
When you pull up the front panel, the hood
(light and extraction motor) switches on again
as previously set.
It is advisable to switch on the extractor hood
a few minutes before starting cooking and
then to leave it running for approximately 15
minutes afterwards to ensure that all odours
are extracted.
Attention!
The hood doesn't switch-ON if the flap is
not mounted.
Maintenance
Before performing any maintenance
operation, disconnect the hood from the
electricity.
Grease filter
The hood has 2 metal grease filters.
To clean the filter, proceed as follows:
Remove the metal grease filters pulling
upwards and extract outwards (Fig. 3).
The metal grease filter lasts forever and
must be washed either by hand or in the
dishwasher (65°C) with suitable detergents.
The grease filters must be washed at least
once a month.
Attention! When washed in a dishwasher,
the metal grease filter may discolour.
Before refitting the filter ensure that it is
perfectly dry.
Position of filters is interchangeable.
Charcoal filter
This hood can be equipped with a circular
charcoal filter.
The charcoal filter cannot be regenerated or
washed.
The charcoal filter must be replaced
every 4 months.
To remove the carbon filter, unlock the knobs
D (Fig. 4) and pull the filter out.
Attention
Failure to observe the rules for cleaning the
appliance and changing and cleaning the
filters may cause fires. Therefore, we
recommend observing these instructions.
Changing the bulbs
a. Disconnect the hood from the electricity.
b. Remove the grease filters.
c. Always replace burnout bulbs with olive-
shaped max 40 Watt (E14) bulbs.
d. Refit the grease filters.
— Before calling for Repair service because
the hood fails to light up, make sure the
bulbs are screwed in tightly.
Cleaning
To clean the outside of the hood use a cloth
moistened with denatured alcohol or neutral
liquid detergents.
Never use products containing abrasive.
Wipe brushed stainless steel in the same
direction as the brushing to avoid scratching.
Light switch
Motor speed
selector
O 1 2 3
O I
