background image

13

Cleaning the interior

Before using the appliance for the first time, wash
the interior and all internal accessories with luke-
warm water and some neutral soap so as to remove
the typical smell of a brand-new product, then dry
thoroughly.

Operation

Insert the plug into the wall socket. The pilot light
(E)will light up, indicating that the appliance is
powered. Turn the thermostat knob (B), clockwise,
beyond the ÇOÈ (STOP) position. The freezer will
start to operate.

To stop operation, simply turn the thermostat knob to
position ÇOÈ.

Temperature regulation

The temperature is automatically regulated and can
be increased to achieve a higher temperature
(warmer) by rotating the thermostat knob toward
lower settings or reduced (colder) rotating the knob
towards higher settings.
However, the exact setting should be chosen
keeping in mind that the temperature inside the
refrigerator depends on:
¥

room temperature;

¥

how often the door is opened;

¥

the quantity of food stored;

¥

location of appliance.

A medium setting is generally the most suitable.

USE

Do not use detergents or abrasive
powders, as these will damage the finish.

Contol Panel

A.

Pushbutton for the interruption of the sound 
signal

B.

Thermostat knob

C.

Normal/Super switch

D.

Super control light

E.

Pilot light

F.

Warning light

G.

Pushbutton for the interruption of the sound 
signal

Quick-freezing

For quick-freezing, slide the knob (C) towards the
left. The quick-freezing light (D) will then light up.

Warning light (F)

The temperature alarm light turns on automatically
whenever the temperature within the freezer rises
above a certain value which might endanger
satisfactory long-term conservation.

It is perfectly normal for the temperature alarm light
to remain lit up for a short time after the freezer is
initially turned on. It will remain lit up until the
optimum temperature for the conservation of frozen
food is attained.

B

C D E F

A

1

2

3

4

5

6

G

Sound signal alarm (A)

This appliance incorporates an alarm which gives off
a sound signal when the temperatureinside the
freezer has risento a point where the safe storage of
frozen food is no longer ensured.

This alarm will come on when the appliance is just
being started or when the food has just been put in
the freezer. This sound can be turned off be
depressing pushbutton (A).

Sound signal alarm (G) 

This appliance incorporates an alarm which gives off
a sound signal when the door remains open for
more than 30 seconds. The signal can be stopped
by closing the door or by depressing the pushbutton
(G).

Summary of Contents for JGI4423










Reviews: