JA95-001 Audio Controller
Operating Manual
Page 4
CAUTION
:
If an unapproved connector or cable is used, damage
to the unit or to any attached device may occur. If in doubt, contact
JAC for a list of approved cables, music sources and devices.
(6)
Music/Configuration Connector (
♫/io)
(7)
Transmit Annunciator - TX
(8)
Transmit Selector
Each of the transmit selector positions is linked by a white line to the
corresponding transmit select annunciator, transceiver switch and legend.
This is a music input that is
compatible with most music
players. It accepts a 3 pole 3.5mm
stereo plug with a slim diameter
connector housing.
(This connector port is also used
during installation to change
configuration settings.)
This is a dead-front annunciator that will
illuminate when the unit is transmitting.
The default legend is ‘TX’, but it is
interchangeable to allow customization.
This is a rotary six-
position control
that is used to
select
transmission via
one of the five
transceivers or the
public address
system (PA).
The appropriate annunciator will light
green
to show which transceiver is selected for
transmit - ‘PA’ in this example.
