REV
.
11
30-05-2017
INSTALLATION
,
USE AND MAINTENANCE MANUAL
JULIA 3000-5000-7000-8000-8500-9000
-
HP
4 / 51
Jurop
SpA
Via Crosera n° 50
33082 Azzano Decimo, PN (Italy)
T
EL
.
+39
0434
636811
F
AX
.
+39
0434
636812
http://www.jurop.it
e-mail: info@jurop.it
1.1.
Introduction
• This booklet contains the necessary instructions for a correct
installation, running, use and maintenance of the pump, as well as
some practical suggestions for a safe operating.
• The knowledge of the following pages will grant a long and
trouble-free operation of the pump.
• Following the instructions below contributes to limiting pump repair
expenses by extending its duration, as well as preventing hazardous
situations, thereby increasing its reliability.
• If the pump is driven by an hydraulic motor please refer to
manufacturer's specific manual.
• It is recommended to:
-
Read, understand and apply carefully the instructions before
running the pump.
-
Keep the booklet at hand and have it known to all operators.
• Below is a brief description of the symbols used in this manual.
If these safety rules are not respected, operators can be
injured and the Julia group or oilers damaged remarkably.
If these safety rules are not respected, the Julia group or
system can be damaged.
Suggestions for an environment friendly use of the Julia
group.
Useful information for an easy usage and maintenance of
the Julia group.
• The graphic representations and photographs contained in this
manual are there to illustrate the product in the parts that make it up
and in specific operating phases. Though the model shown in the
manual may differ from the one purchased, the operating principle at
the base of the illustrated operating phase is the same.
• Every Julia group can be installed
only if it has a nameplate
.
Julia is delivered complete with identification plate, installed on top of
the gearbox (see Fig. 1.1). The plate specifies: Model, Serial number,
Year of manufacture, Max pressure, Max speed and pump model.
Fig. 1.1
1.2.
Spare part request
• Use only
genuine spare parts
for maintenance and repairs. To
order spare parts, provide the following details:
ESEMPIO:
a) The model of the Julia (see Julia tag):
J
ULIA
3000
b) The serial number of the Julia (see tag):
K40030
c) A description of the parts (see parts list):
S
PLINED SHAFT
d) The quantity (see parts list):
n°1 pz
e) The code number of the part (see parts list):
16500 019 00
1.3.
Warranty terms and conditions
• Compliance with the installation, use and maintenance instructions
provided by this manual
is crucial for the recognition of warranty
against defective parts.
1. General warnings
