Justgo.uk.com
12
Switching on
For gas operation, open the regulator tap on the gas
bottle.
For van engine operation, ensure the vehicle ignition is
turned on
For electric hook up operation, ensure the vehicle is
hooked up to a suitable electric supply
Press and hold the On/Off button
1
until the button
lights up green and the display panel shows. To save
energy, after approximately 10 seconds the display is
dimmed.
Press the power source selection button
2
to select
the required energy source
3
. The symbols for the
operating modes are:
- Plug icon - Electric hook up
- Battery icon - Van engine
- Flame icon – Gas
Please note:
When selecting gas operation, a ticking
sound can be heard until ignition has completed
successfully.
4
1
2
3
Fridge 2
Fridge Temperature Control
When turned on, the fridge automatically selects
the thermostat position selected last. This position
can be adjusted manually by using the ‘cooling level’
selection button
4
The illuminated bars
5
display the cooling level
indicator. Please note, the lowest bar display is the
highest cooling level.
It takes a few hours until the fridge reaches an
optimum operating temperature. When changing
over the operating mode, the thermostat setting will
be maintained as the fridge temperature is retained
regardless of the type of energy being used.
Switching Off
Press and hold the On/Off button
1
until all lights
on the display go out.
When operated with 12v, the fridge draws power only
from the starter battery of the vehicle. The starter battery
only supplies the fridge with 12v when the vehicle engine
is running. If the vehicle engine is switched off, the cooling
no longer operates. For this reason, we recommend
changing to gas operation during prolonged driving
breaks.
Panel controls
1
On/Off
Press & hold button for approximately 2 seconds to
turn on or off.
2
Power Source Selection
Press & hold till energy settings flash, then use left/
right arrows to select desired power source (we
recommend you do not use the automatic setting
display as 'A')
Plug icon - Electric hook up
Battery icon - Van engine
Flame icon - Gas
3
Power Source Display
Displays the power source you have selected from
the detailed symbols in point '2'. Remember for
battery setting, it will only work when the vehicle
engine is runnng.
4
Cooling Level Selection
For temperature settings press button 2 again and
icons (4) will flash. Use left/right arrows to increase/
decrease settings. Press button 2 again to confirm.
After a few seconds the setting lights will go out just
leaving the on/off button illuminated.
