10. Handlebar Installation
Remove two M8*20 Bolts (31) and two Cruve
Washers Ø8* Ø20*2.0(19) from the Front Post
(2).
Insert the Hand Pulse Sensor Wires (17)
through into the bottom hole of the Handlebar
(12) and pull it out from the square hole of the
Handlebar (12).
Attach the Handlebar (12) onto the Front Post (2)
with two M8*20 Bolts (31) and two Cruve
Washers Ø8* Ø16*1.5(19) that were removed
11. Computer Installation
Remove four M5x10 Bolts (14) from the back of
the Computer (13).
Connect the Sensor Wire (21) and Hand Pulse
Sensor Wires (17) to the wires that come from
the Computer (13) and then attach the
Computer (13) onto the top end of the Front
Post (2) with four M5x10 Bolts (14) that were
removed.
Pls note coat the Aluminum Rod with PTFE
Lubric.
