Justin JED650, User Manual

Adjusting pad effect     

1. Use the direction key         to switch to EFFECT
2. Press [SET UP] to enter pad effect setting. 

EQ setting

3. Use the direction key          to select EQ type. 
4. Use the direction key          to change EQ value. 

      HI   GAIN=13(default)       range:01---25   
      MID  GAIN=15(default)      range:01---25
      LOW   GAIN=18(default)     range:01---25

DRUM PAD SETTING
PAD SENSITIVITY
RELOAD FAC SET
EFFECT

HI  GAIN=13
MID GAIN=15
LOW GAIN=18
AMBIENCE=OFF

HI  GAIN=13
MID  GAIN=15
LOW  GAIN=18
AMBIENCE=OFF

Ambience setting

RELOAD SETTING
FOR USER01
SET UP FOR YES
 CANCEL FOR NO

5. Use the direction key            to select AMBIENCE
6. Use the direction key            to switch AMBIENCE

   AMBIENCE=OFF
   AMBIENCE=01
   AMBIENCE=02

(When adjusting parameters, press [SET UP] to reset 

  parameters to the default status.)

All 

Go back to default setting                                     

1. Use the direction key            to select RELOAD FAC SET
2. press[SET UP]to go back to the default setting. 
3. Use the direction key           to select saved drum kit. 
    e.g.FOR USER01
4. Press [SET UP] to go back to the default setting
5. Press [CANCEL]to cancel the default setting
 

15

        KIT01  POP01

SONG01              DRUM ON

CLICK=4/4          TEMPO=100

Instruction for pad parameter setting 

1. Pad curve

 The curve is relative to the pad dynamic signal. 

(default:CURVE2)

 CURVE 1:very low dynamic response, high volume. If used to trigger the pads,the curve is flat.
 CURVE2: the standard setting, during playing or when volume changes, it generates maximum 
 natural signal. 
 CURVE3: compared to CURVE2,

 weak force generates relatively big change. 

 CURVE4: compared to CURVE2,

 strong force generates relatively big change.

 CURVE5: compared to CURVE2, 

strong force generates very big change.

2. Threshold 

  Threshold: the minimum force to generate a pad signal. 

   The high threshold needs strong force to generate pad signal. Low threshold needs weak force 

     generate pad signal. 

to 

  Setting threshold needs to refer to playing style and external condition. 
  Threshold range: 1---8

3. Crosstalk

   If the crosstalk is too high, weak force is hard to trigger the pad. If the crosstalk is too low, it is

to lead to crosstalk.

 easy 

4. About saving

   All the changes to the preset drum kit can not be saved in the peset drum kit, but in the user 

kit. 

drum 

DEMO SONG playing         

Select playing DEMO SONG

   1. Press [SONG] to switch to DEMO SONG 

      menu or use the direction Key        to select 
      SONG01

     2. Use the direction key          to  Select the 

       preset DEMO SONG

     3. Press [START/STOP]to play the 
         selected songs

     (refer to DEMO SONG LIST for the DEMO SONG

16