Installation of the pump JUWEL Eccoflow in the filter system
Compact, Standard H and Jumbo
Please proceed as follows in order to install the new pump:
1. Disconnect all electrical devices of the aquarium from the power grid.
2. Remove the adapter (A) from the motor and replace it with the connection ring (B)
as shown on the picture at the new pump JUWEL Eccoflow.
3. Remove the outlet nozzles and remove the old pump and the pump adapter from the
filter.
4. Now arrange the pump on the pump adapter (C) and turn it all the way to the right.
5. Firmly place the new pump on the separation wall; the outlet of the pump must
point at the round opening in the filter housing.
6. Connect the outlet nozzle to direct the waterflow as desired from the outside to the
outlet opening of the pump. Reinstall the gasket into the round opening of the filter
housing when connecting the outlet. This decreases vibration transmissions.
Now the pump is ready for operation and you may reconnect the electrical devices to
the power grid.
A
C
C
B
Maintenance of the pump JUWEL Eccoflow in the filter system
Compact, Standard H, Jumbo
The pump JUWEL Eccoflow should be checked with regard to functionality and cleaned
at regular intervals (at least once a month).
Please proceed as follows:
1. Disconnect all electrical devices of the aquarium from the power grid.
2. Remove the outlet nozzles.
3. Remove the pump from the filter.
4. Disconnect the pump adapter (C) and the connection ring (B) from the motor by
turning them counter-clockwise and remove the impeller.
5. Thoroughly clean all components. It is particularly necessary to remove the impeller
from the chamber and remove deposits and dirt from the chamber itself as well as the
impeller. The function of the pump will be impaired otherwise. Also check the impeller
for damage and possible signs of wear of the magnet.
After that, please reinstall the pump in reverse order in the filter.
C
B
4