10
ENGLISH
You can listen to the playback sounds with
cordless headphones—KS-HP2.
Installing the batteries
CAUTIONS:
• The supplied batteries are not rechargeable.
DO NOT recharge them; otherwise, battery
leakage or explosion may result.
• Insert the batteries with the correct polarity
“+” and “–” to prevent the battery leakage
or explosion.
Before using the cordless headphones:
The headphones give best results when used
within about 2 m (6.6 feet) from the transmitter.
These headphones need to receive infrared (IR)
signals sent from IR transmitters on the monitor.
Therefore, if you use the headphones where the
signals cannot be received in a straight line of
sight, noises may be generated.
Main elements and features
1
IR sensors
• DO NOT cover the IR sensors, as
reception will become poor.
2
ON/OFF button
• The power automatically shuts off in the
following cases:
– The headphones are used for about 4
hours.
– No signal is received for about 4
minutes.
• You can turn on the power again by
pressing the button.
3
POWER lamp
4
Volume control
Playback sounds are transmitted through IR
transmitters to the cordless headphones.
When using the headphones, set the monitor
menu item “IR” to “ON.” (See page 14.)
WARNING:
DO NOT use the headphones while driving.
Shutting out all outside sounds while driving
is dangerous and may result in a traffic
accident.
Headphones —
KS-HP2
Left side
Right side
IR transmitters
POWER
VOL
Batteries (R03/AAA)
— supplied only for
initial setup purpose
EN07-10_KV-MRD900[J]f.indd 10
EN07-10_KV-MRD900[J]f.indd 10
05.3.19 11:30:53 AM
05.3.19 11:30:53 AM
