G-1
Warnings, Cautions and Others
IMPORTANT
for the U.K.
DO NOT cut off the mains plug from this equipment. If the
plug fitted is not suitable for the power points in your home
or the cable is too short to reach a power point, then obtain
an appropriate safety approved extension lead or consult
your dealer.
BE SURE
to replace the fuse only with an identical
approved type, as originally fitted.
If nontheless the mains plug is cut off ensure to remove the
fuse and dispose of the plug immediately, to avoid a possi-
ble shock hazard by inadvertent connection to the mains
supply.
If this product is not supplied fitted with a mains plug then
follow the instructions given below:
IMPORTANT:
DO NOT
make any connection to the terminal which is
marked with the letter E or by the safety earth symbol or
coloured green or green-and-yellow.
The wires in the mains lead on this product are coloured in
accordance with the following code:
Blue :Neutral
Brown :Live
As these colours may not correspond with the coloured
markings identifying the terminals in your plug proceed as
follows:
The wire which is coloured blue must be connected to the
terminal which is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the
terminal which is marked with the letter L or coloured red.
IF IN DOUBT - CONSULT A COMPETENT ELECTRICIAN.
CAUTION
To reduce the risk of electric shocks, fire, etc.:
1
Do not remove screws, covers or cabinet.
2
Do not expose this appliance to rain or moisture.
Caution: Proper Ventilation
To avoid risk of electric shock and fire, and to prevent damage,
locate the apparatus as follows:
1
Front
: No obstructions and open spacing.
2
Sides/ Top/ Back : No obstructions should be placed in the
areas shown by the dimensions below.
3
Bottom
: Place on the level surface. Maintain an
adequate air path for ventilation by plac-
ing on a stand with a height of 10 cm or
more.
Caution —STANDBY/ON
button!
Disconnect the main plug to shut the power off completely. The
STANDBY/ON
button in any position does not disconnect
the main line. The power can be remote controlled.
• When the unit is on standby, the STANDBY/ON indicator lights
red.
• When the unit is turned on, the STANDBY/ON indicator lights
green.
IMPORTANT FOR LASER PRODUCTS
CLASS 1 LASER PRODUCT
CAUTION
1
Invisible laser radiation when open and interlock failed or
defeated. Avoid direct exposure to beam.
CAUTION
1
Do not open the top cover. There are no user serviceable
parts inside the unit; leave all servicing to qualitied service
personnel.
2
Use of controls, adjustments or performance of procedures
other than those specified herein may result in hazardous
radiation exposure.
CAUTION
1
Do not block the ventilation openings or holes. (If the venti-
lation openings or holes are blocked by a newspaper or
cloth, etc., the heat may not be able to get out.)
2
Do not place any naked flame sources, such as lighted
candles, on the apparatus.
3
When discarding batteries, environmental problems must
be considered and local rules or laws governing the dis-
posal of these batteries must be followed strictly.
4
Do not expose this apparatus to rain, moisture, dripping or
splashing and that no objects filled with liquids, such as
vases, shall be placed on the apparatus.
CAUTION
■
■
■
■
About the Internal Cooling Fan
This unit includes an internal cooling fan, so as to allow for
high-power operation within a small space.
This fan comes on when the sound level is set high, and may
also come on even at low sound levels if the internal temper-
ature rises. To ensure effective fan operation, please leave
at least 15cm clearance between the rear of the unit and the
wall, and at least 1cm clearance on each side of the unit.
Front view
Side view
CA-FSX5
SP-FSX5
SP-FSX5
CA-FSX5
SP-FSX5
SP-FSX5
Front view
Side view
FS-X5(B)_E.book Page 1 Friday, March 28, 2003 2:49 PM
