19
Setting the Sleep Timer
When a source is playing, use the Sleep Timer to turn the System
off after a certain number of minutes. By setting the Sleep Timer,
you can fall asleep to music and know that your System will turn
off by itself rather than play all night.
■
You can only set the Sleep Timer when the System is on.
Note:
The clock must be correctly set for the timers to work.
If the clock has not been set, the CLOCK indicator will
flash on the display when you press the TIMER button for
more than 2 seconds, and then the display alternates
between “ADJUST” and “CLOCK” for about 5 seconds.
1 Play a CD or a cassette tape, or tune in to
the desired station.
2 Press the SLEEP button on the Remote
Control.
The SLEEP indicator lights up.
3 Set the length of time you want the
source to play before shutting off.
•
Each time you press the SLEEP button, it changes the number
of minutes shown on the display in this sequence:
After setting the number of minutes for the Sleep Timer, the
display will stop flashing and return to the previous state.
The System is now set to turn off after the number of minutes
you set.
To confirm the Sleep Time
When the SLEEP button is pressed, the remaining sleep time is
displayed.
To cancel the Sleep Timer setting
Press the SLEEP button until the SLEEP indicator goes out on the
display.
Turning off the System also cancels the Sleep Timer.
7 Press the
¢
or
4
button until “TUNER”
appears and the REC indicator lights up
on the display.
The display changes as shown below.
8 Set the volume level.
1. Press the TIMER button on the Unit.
The current volume setting flashes on the display.
2. Press the
¢
or
4
button to select the volume level.
--
: The current volume level will be used.
0 to 40 : When the timer is turned on, the Volume will be
automatically set to the selected level.
To turn off the volume while the Recording Timer is
working,
set the volume level to “0”.
9 Press the TIMER button on the Unit.
The timer setting is completed and the display returns to the indi-
cations before you set the timer. The Timer indicator remains lit.
Note:
If you change the station before turning off the System,
the last received station will be recorded.
10 Insert a blank or erasable tape into the
Cassette Deck.
•
Make sure that the tape has the enough length for recording.
11 Press the
button to turn off the
System.
To cancel the timer,
press the TIMER button for more than 2
seconds. The REC and Timer indicators go out on the display.
To re-activate the canceled timer,
press the TIMER button for
more than 2 seconds to light the REC and Timer indicators.
To confirm the timer settings,
cancel the timer once by
pressing the TIMER button, and press the button again for more
than 2 seconds. Then, press the TIMER button repeatedly, to see
the current timer settings (ON time, OFF time, source, and
volume). Press the TIMER button to set the timer again.
To change the timer setting,
repeat the setting procedure from
the beginning.
•
When the timer turns on, the Timer indicator starts flashing.
Note:
If the Unit is turned on when the timer-on time comes,
Recording Timer does not work.
CAUTION:
If the System is unplugged, or a power failure
occurs, the timer will be canceled. You will need
to reset the clock first, then the timer.
10
20
30
60
90
120
Canceled
EN10-22.UX-V100[B]f
12/12/00, 12:34 PM
19
