12
Before Operation-VCR part
Tuning in a video channel on your
TV
Notes:
The output frequency of this DVD+VCR is set at
UHF channel 36. If channel 36 is already used by
another TV station, or if the picture is distorted, you
can change the transmitter channel of your
DVD+VCR. Stages 5 ~ 8 will show you how to
change the output frequency of your DVD+VCR.
Your TV receives signals from the DVD+VCR like
another TV station. You have to select a channel
number on your TV and tune it in so that you may
watch video tapes. If you have used a SCART then
your TV should already have a dedicated video
channel built into it, usually called AV.
1. Make sure that you have correctly installed your
DVD+VCR as described earlier in this book.
Press
1
1/
/++
to turn on your DVD+VCR.
Turn on your TV.
2. Insert a pre-recorded video tape into your
DVD+VCR and press
N
N
on the remote control.
Select a TV channel which you wish to watch
video.
Don’t worry if you don’t have a video-tape to play
at this stage! If you switch your DVD+VCR on and
continue stages
3 ~ 4
, instead of seeing video
playback tune your TV until you see a bright blue
screen.
3. Tune this channel until the video picture is sharp
and the sound is clear.
If you have used a SCART or AUDIO and VIDEO
cables you will not have to tune your TV, simply
select the AV channel. The AV channel is already
pre-tuned for optimum video playback on your TV.
4. Store this channel on your TV.
You will need to look at the TV instruction book if
you do not know how to do this.
5.
Only carry out stages 5 ~ 8 if you cannot
obtain clear video playback as described in
stages 1 ~ 4.
Select a TV channel which you wish to watch
video.
Make sure that your DVD+VCR is in standby
pressing
1
1/
/+
on the remote control (only the clock
will be displayed).
6. Press
PROG. (-/+)
on the front of your DVD+VCR
for more than 4 seconds.
RF36
will appear in the display window.
The following picture will be displayed on the TV
screen.
7. Use
PROG. (-/+)
to select another video channel.
You may select any channel number between 22
and 68.
8. Select a TV channel which you wish to watch
video.
Press
1
1/
/+
on the front of your DVD+VCR when
you have finished.
Tune this channel so that a bright blue screen
appears.
Store this channel on your TV.
Notes:
Make sure that you have correctly installed your DVD+VCR
and successfully tuned in a dedicated video channel on your
TV. If you do not tune in a dedicated video channel on your
TV you will be unable to view and record video tapes!
Using your VCR for the very
first time
Following picture will display on the TV screen
when you have just connected your video
recorder for the very first time.
To make tuning TV stations, please follow stages
3 to 4 as shown "ACMS" (see p.14).
ACMS
OK
i
Pr-12
ACMS
RF CHANNEL 36
