7
2
Connecting the main plug to the AC outlet.
Setting up your TV
CAUTION
• Turn off the equipment including the TV before connecting.
VHF/UHF outdoor aerial
75-ohm coaxial cable (not supplied)
1
Connecting the aerial cable.
3
Inserting batteries into the remote control.
Insert two batteries by following the
+
and
-
polarities
and inserting the
-
end
fi
rst.
CAUTION:
Follow the cautions printed on the batteries.
Notes:
• Use AA/R6/UM-3 dry cell batteries.
• If the remote control does not work properly,
fi
t
new batteries. The supplied batteries are for testing,
not regular use.
4
Turn on the TV by pressing the main power button.
JVC logo appears on the screen.
V
L
R
R
L/MONO
Y
C
B
C
R
/V
V
S
OVER
L
R
/MONO
OUTPUT
VIDEO-1
COMPONENT
(VIDEO-2)
INPUT
INPUT
Rear of TV
AV-2156BE
VHF/UHF outdoor aerial
VCR
If you connect a VCR, connect the aerial output jack of your VCR and
the aerial jack on the TV with aerial cable. Then connect the output
jacks of your VCR and the VIDEO-1 input jacks of the TV with the
video cable (or S-VIDEO cable if available) and audio cables. For
details, see the manual of your VCR.
The illustration shown is just a sample. It may not be same as your TV.
JVC logo will appear on the screen again at the phase of “SETUP
TOUR RESTART?” function. Then the initial setting can be performed
according to page 8.
Note:
While in the INSTALL menu with the cursor pointing at INSTALL, pressing
the blue button will also display the JVC logo.
GGT0120-001A-H-EN.indd 7
GGT0120-001A-H-EN.indd 7
03.05.2006 14:26:35 Uhr
03.05.2006 14:26:35 Uhr