29
Plug In Menu
AUTO TUNER SETUP
INPUT - A
INPUT - B
:
:
AIR
CABLE
START
AUTO TUNER SETUP
The AUTO TUNER SETUP feature automatically scans through all the channels your television can receive
and memorizes only the channels with clear, active signals. This means when you scan through the channels,
you will receive only channels with good signals, no more annoying static or dead air.
The AV-61S902 has two RF signal inputs with can be setup independent of each other. For example, you can
set one input up to receive signals from an antenna and the other to receive signals from a satellite dish.
To run AUTO TUNER SETUP, use the
5∞
arrows to move to the AUTO TUNER SETUP option in the PLUG
IN MENU. Select the option by pressing
2
or
3
.
The AUTO TUNER SETUP menu will now appear. Use the
2 3
arrows to select antenna or cable as the sig-
nal source for INPUT-A (see pages 12 to 14 for information on connecting to an antenna or cable). Use the
5
∞
arrows to move to INPUT-B if you wish to set up INPUT-B as well, or to START to begin AUTO TUNER
SETUP. If you select INPUT-B, use the
2 3
arrows to select antenna or cable as the signal source and then
move to START. Press
2
or
3
to begin AUTO TUNER SETUP.
The television will now scan through all the channels it can receive, memorizing those with clear, active sig-
nals. AUTO TUNER SETUP will program INPUT-A and then INPUT-B if you have selected it also. Programming
will take several minutes. When it is finished the following message will appear:
You may add or delete channels from the Auto Tuner scan. If there are channels you do not wish to receive or
if the Auto Tuner missed a channel which may have not been broadcasting or had a weak signal, you can
modify the scan using the CHANNEL SUMMARY feature. For information on CHANNEL SUMMARY, see page
32.
AUTO TUNER SETUP
A 48
NOW
PROGRAMMING !
PROGRAMMING OVER!
