10
Menu adjustment
SOURCE SELECT
PICTURE MEMORY
EXT IN
CAMERA
ON
BW
NEGA
MENU/
ENTER
TEXT
MODE
BW/
COLOR
NEGA/
POSI
LIGHTS
2
3 4
5
1
䡵
Functions
The functions and settings for each adjustment item are shown below.
RED LEVEL
0
BLUE LEVEL
0
DIGITAL ZOOM
x 2
JPEG
FINE
LOAD
CANCEL
SAVE
CANCEL
Adjustment item
Functions and settings
Initial value
Adjusts the blue level of the camera picture.
-30 to +30 (in increments of 1 step)
Sets the maximum magnification of the digital zoom.
OFF/x2/x4
• The altered setting will become effective only when the ZOOM button is pressed.
Adjusts the red level of the camera picture.
-30 to +30 (in increments of 1 step)
Selects the settings.
DEFAULT : Returns the current conditions to the initial values (factory-set values).
Select DEFAULT and exit the menu to start operation.
USER
: Changes the current settings to those stored in memory with the SAVE
function shown below. Select USER and press the MENU/ENTER button
to start operation.
CANCEL/DEFAULT/USER
Stores current settings in memory.
Select OK and press the MENU/ENTER button to store the settings in memory.
The stored settings will be applied the next time the presenter is powered up.
CANCEL/OK
Sets the compression rate of the JPEG picture captured to a personal computer via
the USB connector.
FINE
: Highest picture quality, but large file size. Normally, use this mode.
NORMAL
: The file size is between FINE and ECONOMY.
ECONOMY : Lower picture quality, but smaller file size.
FINE/NORMAL/ECONOMY
• When E on the rear panel MODE switch is set to 0, there will be no menu display. (refer to MODE on the rear panel on page 8).
• When the camera picture mode is SVGA or VGA, the definition of the menu display is reduced slightly.
• With the digital zoom magnification set to x4, the picture may be pixelated when the magnification is maximized. It is recom-
mended to normally use x2.
• The settings for SOURCE SELECT and FREEZE cannot be saved. When the power is supplied, SOURCE SELECT is set to
CAMERA and FREEZE is set to OFF.
• While the menu is displayed on the screen, settings for TEXT MODE, BW/COLOR, NEGA/POSI and LIGHTS cannot be
altered. To make alteration, first exit the menu display and then change the setting.
䡵
Operation
The adjustment and setting of this unit can be performed
with the on-screen menu displayed by the projector or
monitor.
Press the MENU/ENTER button
1
to display the menu.
Select the adjustment item with the
䊲
button
2
and the
䊱
button
3
.
Set the data with the
䊴
button
4
and the
䊳
button
5
.
When the setting is complete, press the MENU/ENTER
button to exit the menu display.
