English
Page 28
Specifications
Amplifier
Output Power
At Stereo Operation
Front Channels
55 watts per channel, min. RMS, driven into 4 ohms at 1 kHz with
no more than 0.9% total harmonic distortion. (IEC268-3/DIN)
40 watts per channel, min. RMS, driven into 8 ohms at 1 kHz with
no more than 0.9% total harmonic distortion. (IEC268-3/DIN)
40 watts per channel, min. RMS, driven into 8 ohms, 40 Hz to 20
kHz with no more than 0.8% total harmonic distortion.
At Surround Operation
Front Channels
50 watts per channel, min. RMS, driven into 8 ohms at 1 kHz with
no more than 0.8% total harmonic distortion.
Center Channel
50 watts, min. RMS, driven into 8 ohms at 1 kHz, with no more
than 0.8% total harmonic distortion.
Rear Channels
50 watts per channel, min. RMS, driven into 8 ohms at 1kHz, with
no more than 0.8% total harmonic distortion.
Total Harmonic Distortion
0.8 %* at 40 watts output
(8 ohms, 1 kHz)
(* Measured by JVC Audio Analysis System)
Frequency Response (8 ohms)
PHONO
20 Hz to 20 kHz (±1 dB)
TUNER, CD, TAPE, VCR, VIDEO
20 Hz to 20 kHz (±1 dB)
Audio Input Sensitivity/
PHONO (MM)
2.5 mV/47 k ohms
Impedance (1 kHz)
TUNER, CD, TAPE, VCR, VIDEO
200 mV/47 k ohms
Audio Output Level
TAPE, VCR
200 mV
Signal-to-Noise Ratio
PHONO
70 dB/66 dB
(’66 IHF/DIN)
TUNER, CD, TAPE, VCR, VIDEO
87 dB/67 dB
RIAA Phono Equalization
±0.5 dB (20 Hz to 20 kHz)
Loudness
+5 ± 2 dB at 100 Hz
(Volume Control at –40 dB)
Video Input Sensitivity/
VCR, VIDEO
1 Vp-p/75 ohms
Impedance
Video Output Level
VCR, MONITOR OUT
1 Vp-p (at 1 Vp-p input)
Synchronization
negative
Signal-to-Noise Ratio
45 dB
General
Power Requirements
AC 230V , 50 Hz
Power Consumption
240 watts
2 watts (in standby mode)
Dimensions (W x H x D)
435 x 146 x 403 mm
(17
3
/
16
x 5
3
/
4
x 15
7
/
8
inches)
Mass
8.0 kg (17.7 lbs)
Design & specifications are subject to change without notice
AX-V55BK[E].En
99.2.9, 10:56 AM
28
