Loading Batteries into the Remote Control
Loading the batteries
Removing the batteries
0
If the remote control has to be brought closer to the unit
to operate, it means that the batteries are wearing out.
Replace the batteries with new ones (AAA).
0
Insert the batteries according to the
t
s
marks.
Be sure to insert the
s
end first.
When removing the battery, do so from the
t
end.
0
If an error occurs while using the remote control,
remove the batteries and wait for five minutes. Load
the batteries again and operate the remote control.
Effective Range of Remote Control Unit
When aiming the remote control toward the sensor on this
unit (front or rear), ensure that the distance to the sensor
is within 7 m.
If the remote control fails to work properly, move closer
to this unit.
30°
30°
20°
20°
Remote Control
This unit
Control through reflection off a screen, etc.
Ensure that the total of distance A (between this unit and
the screen) and distance B (between the remote control
and the screen) is within 7 m.
* As the efficiency of signals reflected from the remote
control unit varies with the type of screen used, the
operable distance may decrease.
A
B
30°
30°
20°
20°
20°
20°
20°
20°
Screen
Remote Control
This unit
CAUTION
0
Do not put the remote control in a place with an exposure to direct sun light or high temperature. It may deformed
due to heat, or the internal components may be adversely affected resulting in fire hazard.
0
Remove the batteries from the remote control when storing the remote control. Storing the remote control for a
prolonged period without removing the batteries can cause battery leakage.
16
Getting Started
