Viewing Videos
MEMO
0
Connect the power cord, and ensure that the “STANDBY/ON” indicator
lights up in red.
1
Turn on the power
Remote control: press the
C
[ON] button
Projector unit: press the
A
button
LIGHT
WARNING
STANDBY/ON
LIGHT
WARNING
STANDBY/ON
DB
AN BY/O
DB
AN BY/O
During startup
“STANDBY/ON” lights up (green)
In standby state
“STANDBY/ON” lights up (red)
2
Choose the image to project
Remote control:
Button
Terminal
[INPUT 1]
DisplayPort 1
[INPUT 2]
DisplayPort 2
[INPUT 3]
DisplayPort 3
[INPUT 4]
DisplayPort 4
[DUAL]
Dual (*1)
[QUAD]
Quad (*2)
*1, *2: Refer to “Types of Possible Input Signals”P. 64
Projector unit: press the [INPUT] button to switch the input
0
Play back the selected device to project the image.
To hide the image temporarily
Press the [HIDE] button on the remote control
0
The “STANDBY/ON” indicator light starts to blink in green. When “LED Indication” is set to “Off”, the indicator does
not blink.
0
Press the [HIDE] button again to resume display of the image.
0
The power cannot be turned off when the image is temporarily hidden.
STANDBY/ON
LIGHT
WARNING
INPUT 1
DISPLAYPORT
INPUT 2
DUAL
INPUT 4
INPUT 3
QUAD
1
1 3
2
2
3
This unit
Remote Control
24
Operate