Connecting the Projector
0
Do not turn on the power until connection is complete.
0
The connection procedures differ according to the device used. For details, please refer to the instruction manual of
the device to be connected.
0
This projector is used for projecting images. To output the audio of connected devices, please connect a separate
audio output device, such as an amplifier or speaker.
0
Some cables cannot be connected to this unit due to the size of their connector cover.
Connecting to the DisplayPort Terminals
DisplayPort Terminal
This Unit
PC, etc.
DisplayPort Cable (Sold Separately)
To [DisplayPort 1] to [DisplayPort 4]
Input Terminals
0
For single-channel input signals, connect to one of the [DisplayPort 1], [DisplayPort 2], [DisplayPort 3] or [DisplayPort
4] input terminals.
0
For two-channel input signals, connect to the [DisplayPort 1] and [DisplayPort 3] input terminals.
0
For four-channel input signals, connect to the [DisplayPort 1] to [DisplayPort 4] input terminals.
“Types of Possible Input Signals” (P. 64)
0
Video images may not appear if a cable that does not support HBR2 is used. Use a cable that supports HBR2.
0
When disconnecting the DisplayPort cable, make sure to release the latch and unplug the cable.
Connecting to the LAN Terminal
Desktop PC, etc.
Server
Hub
Network
Connection Cable
(Sold Separately)
This Unit
To [LAN] Terminal
0
The network is used to control this unit. It is not used for sending or receiving video signals.
0
Please contact your network administrator for information concerning the network connection.
0
For more information on control, please refer to “External Control”P. 57.
22
Set up
