3
Turn off the power
Remote control: press the
B
[STANDBY] button
Projector unit: press the
A
button
0
While the “Are you sure you want to turn off?” message is displayed, press the button again.
0
The laser light source and IR light source turn off, and the “STANDBY/ON” indicator switches from a green
light to a red blinking light.
0
After the light goes off, the fan will run for about 10 seconds to cool down the light source (Cool-down mode).
Do not disconnect the power cable while cooling is in progress.
0
After about 10 seconds, the “STANDBY/ON” indicator switches from a blinking red to a solid red light.
LIGHT
WARNING
STANDBY/ON
DB
TAN
Y/O
LIGHT
WARNING
STANDBY/ON
DB
In standby state
“STANDBY/ON” lights up (red)
In the Cool-down mode
“STANDBY/ON” blinking (red)
CAUTION
0
The power cannot be turned off within approximately 30 seconds after it has been turned on.
0
The power cannot be turned on again while cooling is in progress (10 seconds).
0
Pull out the power plug when the unit is not to be used for a prolonged period of time.
0
If the indication of indicator differs from the description, refer to “Indicator Display on the Main Unit”P. 69 for details.
25
Operate
