34
English
It is very easy, and can be very disappointing, to forget to put in a tape, or to accidentally leave a
tape in Deck B you don’t want recorded over. Although this happens to almost everyone at one time
or another, we hope it won’t happen to you!
To Change the Recording Timer Setting
To change the settings for the REC Timer, repeat the setting procedure from the beginning.
Turning the REC Timer On and Off
——————————————————
Once the REC Timer has been used to record a source, the setting is maintained but the Timer is set
to OFF.
To turn the REC Timer off before the timer starts,
press the TIMER/CLOCK button until “REC”
appears in the display, then press the CANCEL button. “OFF” appears in the display and the REC
indicator goes out.
To record at the same time again,
press the TIMER/CLOCK button until “REC” appears in the
display, then press the SET button. The ON TIME, OFF TIME, channel frequency, and preset
channel number are displayed then the display reverts to the previous display, before the Timer was
set.
CAUTION: If the CA-D622T is unplugged, or a power failure occurs, the timer setting will be erased
in a few days. If the settings are erased in this way, reset the timer settings.
Setting the SLEEP Timer
Use the Sleep Timer to turn the Unit off after a certain number of minutes when it is playing. By
setting this timer, you can fall asleep to music and know your Unit will turn off by itself rather than
play all night.
❏
You can only set the Sleep Timer when the Unit is on and a source is playing.
To set the SLEEP Timer, follow this procedure:
1.
With the CA-D622T on and a source playing, press the SLEEP button on the Remote Control.
The message “SLEEP” appears on the display.
2.
Set the length of time you want the source to play before shutting off.
❏
Each time you press this button while the “SLEEP” indicator is blinking, it changes the
number of minutes shown on the display in this sequence:
→
10
→
20
→
30
→
60
→
90
→
120
→
Cancelled
→
(back to the beginning)
When the number of minutes you want shows on the display, just wait 5 seconds until the indicator
stops blinking, and is lighted steadily.
The Unit is now set to turn off after the number of minutes you set.
To Change the SLEEP Timer Setting
Press the SLEEP button until the number of minutes you want appears on the display.
To Cancel the SLEEP Timer Setting
Press the SLEEP button until the “SLEEP” indicator goes off on the display.
Turning off the Unit also cancels the SLEEP Timer.
SLEEP
SLEEP
EN01-38.CA-D322T[C]/F
2/12/98, 10:31 AM
34
