– 48 –
There are three timers available—Recording Timer, Daily
Timer, and Sleep Timer.
Before using these timers, you need to set the clock built in
the unit.
• In addition to these three timers, you can also use Auto
Power Off to shut off the power automatically.
Setting the Clock
You can set the clock whether the unit is turned on or off
(on standby).
• If you have activated the power consumption saving
mode (“DISPLAY OFF”), you cannot adjust the clock
while the unit is turned off (on standby). For details, see
page 14.
On remote control ONLY:
1
Press CLOCK/TIMER.
The hour digit in the main display starts flashing.
2
Press
¡
/
¢
or
4
/
1
to adjust the hour, then
press SET.
• If you want to correct the hour after pressing SET,
press CANCEL.
The hour digit starts flashing again.
3
Press
¡
/
¢
or
4
/
1
to adjust the minute,
then press SET.
The built-in clock starts working.
To adjust the clock again
Once you have adjusted the clock, you need to press
CLOCK/TIMER repeatedly until the clock setting screen
appears in the main display (the hour digit starts flashing).
When you unplug the AC power cord or if a power
failure occurs
The clock will be reset to “0:00” in about one minute.
Using Recording Timer
With Recording Timer, you can make an unattended
recording.
• You can set Recording Timer whether the unit is turned
on or off (on standby).
• To correct a misentry any time during the process, press
CANCEL.
• To cancel the setting any time during the process, press
CLOCK/TIMER.
How Recording Timer actually works
The unit automatically turns on about 3 minutes before
timer recording starts, then turns off the volume and starts
recording on CD Recorder when the timer on-time comes.
When the timer off-time comes, the unit automatically
turns off (stands by).
• Recording Timer works only once, but the timer settings
remain stored in memory.
Before you start....
• Make sure that a recordable CD-R or CD-RW is
inserted on the CDR disc tray. If not, insert a
recordable CD-R or CD-RW.
• When you want to record from the external
component (“LINE”), make sure the input you want
to use is currently selected—either “ANALOG IN” or
“DIGITAL IN.” (See page 34 for more details.)
On remote control ONLY:
1
Press CLOCK/TIMER repeatedly until the
Recording Timer on-time setting screen appears in
the main display.
The
(Timer) indicator lights and the REC
(Recording Timer) indicator starts flashing on the
display.
• Each time you press the button, the timer mode
changes as follows:
* “0:00” is the initial setting time at the factory.
Continued
REC
CD
REC
=
ON 0:00
=
DAILY
=
ON 0:00
=
0:00
=
Canceled
=
(back to the beginning)
To be continued
EN47-52_CA-NXCDR7R[B]_f
01.7.23, 10:02 AM
48
