1-14
NX-HD10
Prior to performing the following procedure, remove
the top cover, the HDD board assembly and the front
panel assembly.
<Front assembly section>
Remove the two screws
X
attaching the bracket.
Remove the eight screws
Y
attaching the function
board.
1.
2.
Removing the Function switch board
(See Fig.29~31)
Remove the two screws
Z
and pull out the jack
board toward the rear.
1.
Removing the Jack board (See Fig.31)
Fig.29
Fig.30
Fig.31
X
Function switch
board
Function switch board
Y
Y
Y
Jack board
Z
Bracket
Summary of Contents for CA-NXHD10
Page 62: ...3 2 NX HD10 M E M O ...