1-19
NX-HD10
Reference: Refer to the explanation of "Removing
the Pickup" on the preceding page.
Note: When reinstalling the pickup assembly,
remove the solder from the shorting round
after connecting the flexible wire coming from
the pick to the connector CN601.
Reinstalling the Pickup Assembly
(Refer to Figs. 15 and 16.)
1. Fit the P.S. spring and rack plate to the pickup.
2. Insert the shaft into the pickup.
3. Engage the hook
k
of the pickup assembly with the
CH. base assembly first, and set the part
j
of the
rack plate in the opening
I
next. Then, reinstall the
pickup assembly while shifting it to the T-T side
(inward) so that the part
m
of the rack plate is
positioned as shown in Fig. 16.
4. Move the pickup assembly to the center position
and fasten the shaft with the two screws
D
. (Make
sure that the part
n
of the rack plate is correctly
engaged with the middle gear.)
5. After passing the flexible wire coming from the
pickup through the opening of the CH. base
assembly, connect it to the connector CN601.
Removing the Feed Motor Assembly
(Refer to Fig. 17.)
Remove the CL. base assembly and tray.
Remove the mechanism P.C. board.
Remove the two screws
E
fastening the feed motor
assembly from the top of the mechanism assembly.
Fig. 15
Fig. 16
Fig. 17
Hook k
Part j
Pickup
assembly
Part I
CH. base
assembly
Middle gear
Part n
Rack plate
Part m
Feed motor assembly
E
Summary of Contents for CA-NXHD10
Page 62: ...3 2 NX HD10 M E M O ...