1-7
NX-HD10
Prior to performing the following procedure, remove
the top cover and the HDD board assembly.
Disconnect the card wire from connector CN602 on
the inside of the system control board on the left side
of the body.
Remove the screw
E
on each side of the body.
Remove the two screws
F
on the bottom of the
body.
Release the joint
b
on the bottom and the joint
c
on each side of the body using a screwdriver. Move
the front panel assembly forward.
Release the wire extending from the headphone
board under the front panel assembly from the two
clamps. Set the front panel assembly apart from the
body as far as possible.
Disconnect the wire from connector CN501 on the
system control board and CN301 on the main
amplifier board. Remove the front panel assembly.
1.
2.
3.
4.
5.
6.
Removing the Front panel assembly
(See Fig.5~9)
CN602
Front panel assembly
Front panel assembly
Front panel assembly
Clamp
Headphone board
Front panel assembly
CN501
Front panel assembly
E
Main amp board
CN301
Main amp board
CN501
Joint c
E
F
F
Joint c
Front panel assembly
Joint b
CN602
Fig.5
Fig.6
Fig.7
Fig.8
Fig.9
Clamp
System control board
CN301
System control board
System control board
Summary of Contents for CA-NXHD10
Page 62: ...3 2 NX HD10 M E M O ...