– 10 –
English
Common Operations
Turning On the Power
When you press the play button — CD
3
/
8
, TAPE
2
3
, or
the source selecting button — FM/AM, and MD/AUX (UX-
P5) or AUX (UX-P3), the unit automatically turns on and
starts playback if the source is ready.
To turn on the unit, press
(STANDBY/ON).
For UX-P5: The STANDBY/ON lamp on the unit lights
green.
For UX-P3: The STANDBY lamp on the unit goes out.
To turn off the unit (on standby), press
(STANDBY/
ON) again.
For UX-P5: The STANDBY/ON lamp lights red.
For UX-P3: The STANDBY lamp lights up.
• The CLOCK indicator flashes on the display until you set
the built-in clock. After setting the clock, the clock time
will appear on the display while the power is off.
• A little power is always consumed even while the unit is on
standby.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
When you unplug the AC power cord or if a power
failure occurs
The clock is reset to “0:00” right away, while the tuner preset
stations (see page 13) will be erased in a few days.
Setting the Clock
Before operating the unit any further, first set the clock built
in this unit. When you plug the AC power cord into the wall
outlet, the CLOCK indicator starts flashing on the display.
You can set the clock whether the unit is on or off.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 1
again.
On the unit ONLY:
1
Press CLOCK for more than 2
seconds.
The hour digits start flashing on the display.
2
Press
¢
or
4
to adjust
the hour, then press CLOCK.
The minute digits start flashing on the
display.
3
Press
¢
or
4
to adjust
the minute, then press
CLOCK.
The CLOCK indicator remains lit on the
display.
To check the clock time
Press DISPLAY on the remote control (or CLOCK
on the unit) while playing any source.
• Each time you press the button, the source
indication and the clock time alternate on the
display.
• When you unplug the AC power cord or if a power failure occurs,
the clock loses the setting and is reset to “0:00.” You need to set
the clock again.
• The clock may gain or lose 1 to 2 minutes per month.
STANDBY/ON
STANDBY
/ON
CLOCK
CLOCK
CLOCK
CLOCK
STANDBY/ON
CLOCK
CLOCK
DISPLAY
CLOCK
STANDBY
STANDBY
/ON
UX-P5
UX-P3
Continued
EN01-13.UX-P5&3[[UW,UY]
01.2.26, 11:01 AM
10
